D44 axleshafts

Post by **BlueDodgeRam** » Wed Dec 27, 2006 12:45 am

if anybody has any D44 axleshafts(30 spline) with CAD, let me know. im tryin to get spare parts together. also lookin for Chrysler 9.25 shafts, but i doubt anybodys got those.

hope everybody is havin' a good holiday season

Post by **Steinberg** » Fri Dec 29, 2006 1:34 am

CAD front axle? do you know the shaft lengths?

Post by **BlueDodgeRam** » Fri Dec 29, 2006 1:36 am

yes, CAD sorry didnt post that. drivers side drop as well

Post by **Steinberg** » Fri Dec 29, 2006 1:38 am

added above- what are the shaft lengths?

Post by **BlueDodgeRam** » Fri Dec 29, 2006 1:41 am

not sure, never pulled em out.

Post by **Steinberg** » Fri Dec 29, 2006 1:43 am

i have a short (~16") shaft sitting here. i believe it came out of some dodge w/ unit bearings, but that's all I can tell ya.

Post by **BlueDodgeRam** » Fri Dec 29, 2006 1:47 am

cool, ill check it out when i get back to school if i havent found any by then. ill probably get a full set f&r from somebody on pirate or PS.com. just posted up here to see if anybody had any. thanks though man

Post by **Trailduster79** » Wed Jan 03, 2007 3:16 pm

What year 9.25?

I have some shafts laying around for the 79 and older 9.25's with the 5x4.5 bolt pattern, and I have a complete 87 9.25 as well.

Let me know.

Michael

Post by **BlueDodgeRam** » Wed Jan 03, 2007 3:18 pm

its for my '01 Ram, so i dunno if itll work or not

Post by **Dieselram** » Thu Jan 04, 2007 8:52 pm

I have a spare hub bearing from my old 98 i dunno if it will work on your truck or not