Sinking Creek 4WD Association

Fuck yeah.. looking good. Did you drive it back to foxridge with the front lifted and rear stock height? With the headlights shooting to the moon I imagine that was a fun drive haha

Nah I left it at the shop. I still wanna double check everything before hitting the road and hopefully get the rear swapped to match the front.

Got a lot more done yesterday and finished up my rear suspension. I cut off the frame to right behind the hangers and gained a ton of clearance compared to the stock bumper with the trailer hitch hanging down,

Just the front lifted


Stuck Peter's boner bar on


With the rear shackle flip


Frame before


Frame after


Welding in rear crossmember/ bumper

Man this thing looks awesome already!!

I did some tweaking to the bed today and narrowed it up and cut about a foot off the rear. Now it should clear the 37s and not be a hindrance wheeling. I still want to move the fuel tank up into the bed and i think i'm going to put it inside a tool box to keep it hidden and clean looking.

Got mud tires

That looks really good dude.

Thanks man, and thanks for letting me use some of your stuff I owe you some beer.

Yeah np man, what did you do for your rear cross member?

It's the last bit of 2x4 0.25" box tubing I had left from my jeep rock sliders. It's been riding around in my tool box for 2 years and i finally put it to use. Ideally i would have used 2x6 to box it in completely but i can always change it up later.

This is going to be so badass

Looks good Zach!

Thanks I just ordered a groover so besides grooving the tires and putting on shocks it should be pretty much finished in regards to the major parts before Harlan.

I lincoln locked the rear axle and grooved my tires this weekend.