Sinking Creek 4WD Association

called and spoke with church today

4x8 sheets of 3/16 are $100 a piece
1.75 .120 wall DOM - $3.22 per foot
He told me they don't have 1.75 .120 HREW they have 1.75 .095 HREW thats $1.30 per foot
2x2 .120 Square ERW is $44 for 24 ft piece
1.5 .120 wall DOM would be $2.85 per foot

Everything but the square tube comes in random sizes ranging from 17ft to 24ft

DOM got expensive :(

redneckrapunzel wrote:DOM got expensive :(

That's really not a bad price. Last time we ordered it was just really cheap. If you go back and look at the old orders, less than $3.50 a foot has been considered a pretty good price.

I'm in for a sheet of 3/16. Think Joyce and I are splitting it

Yeah I'm not gettin be sheet anymore, I'm getting a stick of 1.75 .120 wall DOM

Yep I'm good with splitting with aragass

if everyone is good with the prices i would like to order before the end of the week

I'm out on the 1.5 .120 wall DOM but I'm still in for 24ft of 2x2 .120 wall square

grubb wrote:I'm out on the 1.5 .120 wall DOM but I'm still in for 24ft of 2x2 .120 wall square

You should look at getting 1.5 .120 HREW, it is much cheaper.

I'd be curious what a 4'x8' sheet of 18 gauge sells for? Hell maybe I dont want to know....

Alec, that might work. I'm just using it for tube on the sliders I'm building. Would you recommend 1.5 or 1.75?

Also, how much do you think it will cost (I don't think we price checked it), and I know Wong asked, but did anybody confirm if we have access to a tube bender?

grubb wrote:Alec, that might work. I'm just using it for tube on the sliders I'm building. Would you recommend 1.5 or 1.75?

Also, how much do you think it will cost (I don't think we price checked it), and I know Wong asked, but did anybody confirm if we have access to a tube bender?

You should make sliders out of 1.75, pretty standard.

It has typically been at least a dollar per foot cheaper than DOM.

We do not have access to a bender, atm.

Kevin,

You didn't get a price on 1.5 .120 wall HREW.

Sam needs a price on 1 stick of 1.5 .25 wall DOM to replace what he used of mine.

Alright, thanks. I was just going off of shitty jeep forum DIY threads since I'm new to the whole fab stuff.

Kevin, I'll take 17ft or whatever the minimum they have of 1.75 .120 HREW. I wont need more than 15

grubb wrote:Kevin, I'll take 17ft or whatever the minimum they have of 1.75 .120 HREW. I wont need more than 15

You get what you get. The mill cuts them at random lengths and they charge accordingly. You don't know until you get it, typically around 20 feet.