Sinking Creek 4WD Association

Did some work on the bitch over the past couple weeks getting ready for Uwharrie in November.

I have added crossover steering (thanks Steinberg)
I also added a 1410 rear shaft, hopefully it will last longer than the shitty 1310 stuff I had been running.

Just replaced all the wheel bearings in the front axle as well. Should have it all back together tonight or tomorrow morning.

Did your Trailduster come with 60s or did you replace a front 44 with a 60? If you went the replacement route, were you able to get a 60 with flat-top knuckles?

JW,
Henry

it had a 44 and a 9.25 in it from the factory.

I started by putting a 60 in the rear and a 8 lug 44 in the front with 36's.

When I went to 38.5's I put the 60 in the front.

All kingpin Dana 60's have flat top knuckles. The ball Joint 60's are the ones without them.