Sinking Creek 4WD Association

Posted: **Tue Mar 27, 2007 9:53 am**

I believe I'm going to try mounting it behind the cab where I origanlly had planned. After looking at the truck this is really the only place it will work well. Since its a flatbed mounting it on the back of the truck would really get in the way, and if It were on my front bumper it would be mangled in a matter of minutes.

I'm planning on getting all this rigged up friday, so if anyone has a drill and set of bits I could borrow for a couple hours that would be great. Also, Hutch or Henry, if I could borrow one of your SWR meters that would be good too.

Posted: **Tue Mar 27, 2007 12:01 pm**

any particular time you want it? I get out of work around 5.

Posted: **Tue Mar 27, 2007 12:36 pm**

I should be around all day Friday til 7, then free again after 8.

Posted: **Tue Mar 27, 2007 1:09 pm**

hutch wrote:I should be around all day Friday til 7, then free again after 8.

Would it be ok if I brought my rig over friday about noon? It should only take me 30-40min to install it and however long it takes to tune it.

Posted: **Tue Mar 27, 2007 3:07 pm**

VerticalTRX wrote:
hutch wrote:I should be around all day Friday til 7, then free again after 8.
Would it be ok if I brought my rig over friday about noon? It should only take me 30-40min to install it and however long it takes to tune it.

Yeah, just give me a call

605-6500
818-4648

Sinking Creek 4WD Association

Question for those with CB's