Sinking Creek 4WD Association

Posted: **Thu Oct 18, 2007 2:09 pm**

Dude, SLOW DOWN, I looked bad enough already, now you're just making me feel worthless

Posted: **Thu Oct 18, 2007 2:45 pm**

Cuz you are worthless.

Posted: **Thu Oct 18, 2007 2:47 pm**

If you need some first hand experience with the driveshafts, ask me or Clay. I got a High-angle and he has done the square shaft.

Posted: **Thu Oct 18, 2007 2:50 pm**

If your free today come awn over and see if the front shaft Cody has will fit. Then ya can give her a real test on the trail.

And do ya know much about 2-stroke bikes? Im putting one together and dunno if I wanna keep it or find a 4-stroke drivetrain and graft that into the frame.

Posted: **Thu Oct 18, 2007 2:59 pm**

I've done the square as well and so has Krantz. Really not too difficult, it only took me like 2 hours total, so it will probably only take you 15 minutes

Posted: **Thu Oct 18, 2007 4:13 pm**

what are you building with a two stroke motor? I am a motorcycle freak so I know a good bit about them. I ride a 4 stroke now though.

So who has this shaft??? And where is be at? I dont want to make one till I get both cases in.

Posted: **Thu Oct 18, 2007 4:51 pm**

It's at Leach and Cody's as far as I know

Posted: **Thu Oct 18, 2007 4:56 pm**

is that by snuffy's?

Posted: **Thu Oct 18, 2007 8:15 pm**

Posted: **Thu Oct 18, 2007 10:06 pm**

thanks I stopped by

Posted: **Fri Oct 19, 2007 8:03 am**

I also have half of a square shaft (the large tube) if that can help out. I think there is about 12" of tube welded to the joint.

Posted: **Sat Oct 27, 2007 9:58 pm**

Dual cases are in. I Shortened my rear shaft. I made this to help measure the runout when I welded it up. Didnt help much cause the shaft was already bent. I didnt know till I bolted it in this thing. The front shaft is in it now. Just have to finish welding it up. Ran out of wire.

Posted: **Sun Oct 28, 2007 1:22 am**

Sweet man!

Looking good.

Posted: **Fri Nov 16, 2007 7:40 pm**

Lowered the front 2inches and moved the axle another 1inch forward. She is really soft up front now. Going to have to move my shock mounts up because the the decreased lift.

Next ill prolly start building some sliders and maybe a light exo...

Posted: **Mon Jun 16, 2008 11:14 pm**

well since my thermostat failed closed, I managed to over heat my motor and blow the head gasket. So sunday Matt gave me a hand putting in my new to me motor.
8:00am truck gets pulled in the garage.
9:30pm truck goes for a test drive.

Here is a few pics I took.

Old motor out.....

New going in....

Swapped my carb onto it tonight and she is running real good now. Just need to hook up a decent temp guage now....

Thanks for all the help Matt

Sinking Creek 4WD Association

86 toy SAS