Sinking Creek 4WD Association

i'm pretty sure that's not good......but i dont know

also, reasons i need a new main leaf....

my D44 does do that, which you know. I don't get it?

well, mostly i was kidding and just discovered that a min's ago, and what don't you get?

just found out some more intersting info....i have the wrong t-case in the jeep. i have a 231 D instead of the 231 J that's supposed to be there..... now wondering if the trans is the right one....

edit: I have the ax-15, and the 231 D is apparently out of some form of dodge... 94 dakota or 1/2 ton truck according to date on tag and webpage i found.

re-edit: after some investigation, i've got a wider chain and sprockets in this unit, but still unsure if any sye's will work with it. i think so since they dont change sprockets, just the output shaft which i belive is splined to the sprocket ? (un-sure, have not found exploded view...)

re-re-edit: found exploded view, looks like it all just splines ont output shaft, so any sye should work..... yay for the np231D.....yay for the jeep.....

looks like the axle seal mighta taken a dump. I threw two new ones in the box with the gears for ya.

thanks for the seals, and i was just kidding about not knowing what it was....trying to be funny...but no one's taking it as a joke..... its been leaking for a while, just not that bad i have noticed that the drivers side is leaking now too....guess i'll be regearing soon, cause if i take it down, no reason not to put in the lower gears.... fawkin 8.25 seems to have wasted the pinion seal again (hoping not another set of pinion bearings, but it was running a water/gear oil/mud mixture for a few months before i did this particular mod....an actual diff "plug" instead of a rubber push in fluid pumping regulator.....

*NOOB time!*

That's what an 8.25 looks like? I feel better then, because that's what my rear axle and the spare I got from Jim looks like

*end NOOB time*

edit:
after more research, I can't use any of the parts from the 8.25 I got from Jim, as it has 27 spline shafts instead of 29 :(

27 spline will do till you top 33's if you buy some aftermarket shafts, or you can spend that $300 on a dana 44....

or just grow some balls and go portals or mogs

Yoda wrote:or just grow some balls and go portals or mogs

yeah, that too.....

Mogs are portals. The correct sentence would be " Or you could grow some balls and run tons, portals, or duece.5's"

you mean jeeps arent supposed to leak fluids? wierd.

engine=yes, tranny=probably, tcase and axle=shouldn't.....

jonesy wrote:you mean jeeps arent supposed to leak fluids? wierd.

Of course they are. Its in the Jeep bible. Don't let anybody tell you differently.

TerryD wrote:tranny=probably

YOU LIE!! Mine leaks like that's its job