Sinking Creek 4WD Association

D44 Diff cover. Toys by Troy. Rock rash but will still help protect.
$30

JKS 1 inch motor mount lift. Should fit any 4.0. I only have two of the four bolts for some reason.
$30 *Pending*

Front stock TJ CV driveshaft, good condition, was replaced by custom shaft:
$60
40.5 compressed
44 extended (with out taking off the stock boot)

Brand new Tom Wood's CV driveshaft, will fit 4'' lift, have no use for it:
$250
16 compressed
19 extended

Chevy 6 Lug hub and rotor for front d44. Only on Jeep for 1000 miles but does need to be resurfaced.
25$

3.73 Dana 44 ring and pinion. 10,000 miles on them.
25$

This list will be added to as time goes on. Located in Radford.

I am interested in the seats. What are the covers on them and are the covers included?

Might have a friend interested in the bumper/tire carrier, will ask him tomorrow and let you know asap.

Mike

Slinkey wrote:I am interested in the seats. What are the covers on them and are the covers included?

Might have a friend interested in the bumper/tire carrier, will ask him tomorrow and let you know asap.

Mike

As of right now the covers are not included (friend already going to buy them for 25 bucks, they are just the neoprene black and grey in color) I can't stress how new these seats look. Back was taken out of the Jeep right away and I don't think was even sat in. Seat belts and all will go front and rear with the price.

Let me know about your friend. This tire carrier is like new. Can get pics if wanted.

would you split up the seats? I already have my stock rear sitting in the garage, I haven't run one in years... I understand if you don't want to split them up, I can just put the rear on ebay or something, but just putting it out there in case someone else is interested in just the rear.

Either way, put me down for the fronts or the whole deal if you don't want to split them up. I was just down there this past weekend, anyone headed up to NOVA anytime soon???

I will let you know tomorrow about the carrier.

Mike

I am assuming that if they are from a rubicon that they are cloth seats, but just want to double check. Also if you have any pics of the seats it would be great.
thanks
Mike

Slinkey wrote:would you split up the seats? I already have my stock rear sitting in the garage, I haven't run one in years... I understand if you don't want to split them up, I can just put the rear on ebay or something, but just putting it out there in case someone else is interested in just the rear.

Either way, put me down for the fronts or the whole deal if you don't want to split them up. I was just down there this past weekend, anyone headed up to NOVA anytime soon???

I will let you know tomorrow about the carrier.

Mike

I will not be splitting these up. Ebay is you best bet, seen the rear for a good little price. You have first dibs on the seats. Just to let you know I will be heading to NOVA this weekend to pick up a part and if wanted they can be up there for a small fee.

Slinkey wrote:I am assuming that if they are from a rubicon that they are cloth seats, but just want to double check. Also if you have any pics of the seats it would be great.
thanks
Mike

These are cloth seats. I will try and get pics sent to you tonight or tomorrow. Have to get a camera. PM an adress to send them too.

New items added.

PM sent

csult wrote:PM sent

PM replied. New items added.

ya still have the d 30?

I still have the 30. There is someone showing interest but again, first come first serve. Located in Radford. The axle is all cleaned up and painted. Give me an email address for pics.

I'm interested in the front shaft. Need to take some measurements first.

Just let me know. The shaft will be in Radford in a week.

NEW ITEMS. TTT

any interest in parting out the rubicon express lift? if so id be interested in the front upper and lower ca's