Sinking Creek 4WD Association

I need some calipers to turn in for the core charge when I get my new ones. Anyone have some that they'll give me/sell for cheap? I'd like to get them soon.

Thanks,
Tyler

Does the axle you're working on not have any calipers on it?

I've never once had them compare the new with the cores. Theoretically you never have them in the store at the same time anyway.

I'm using them for a rear disk conversion on my 14FF.

Arya Ebrahimi wrote:I've never once had them compare the new with the cores. Theoretically you never have them in the store at the same time anyway.

Thats a good point! I'll just take my calipers from my junk f150 after I "install the new ones".

just take your f150 ones in there when you get the new ones. those dudes(not Mike or Clayton though) in Advance wont know the difference, probably wont even look.

BlueDodgeRam wrote:just take your f150 ones in there when you get the new ones. those dudes(not Mike or Clayton though) in Advance wont know the difference, probably wont even look.

they WILL look .... but they probably wont know the difference ... 'probably' being the opperative word ...

i mean .... shear size is a good indication ... i would do dual pot calipers for dual pot calipers .... good luck.

So are you tellin me that the new calipers are dual pot?

tsmall07 wrote:So are you tellin me that the new calipers are dual pot?

no, they will be single piston calipers.