Sinking Creek 4WD Association

need to sell some stuff from previous project

full size diamond plate chrome truck box, side open lids, no keys (actually still on the truck in my picture) $50 obo

griffin prostreet aluminum radiator part # gri-1-26272-x(on summitracing.com if you need measurments and fitments) sold

aftermarket electric fan from summit racing sold

autometer phantim electric gauges for custom dash -speedo,tach,oil,temp,fuel holding

centerforce ford 5.0 clutch set (was installed but never used/sold engine before project was done) $50

snow tire cables for a dd think they were for 15" tires/ not sure what all sizes they fit $10

turbo105 mig welder need liner in handle cord for wire $40


more stuff to be added

Who makes the gauges? Mechanical or electric? What are you asking for them?

can you measure the tool box. wondering if it will fit in a tundra

the gauges are autometer phantom electric gauges there is a oil,temp,fuel,tach,speedo, and i think i have the volt meter too

i can measure it tomorrow it is in a 03 f150 sport short bed if that helps any(if your bed measurements are close to the ones of mine)

What do you want for the guages? I am interested in guages, radiator, and fan depending on $$.
________
Washington Medical Marijuana Dispensaries

was asking $150 the speedo alone is more than that new

I'll take the guages, will try to be at meeting tomorrow. Is the spedo cable or electric? Can the tach be configured for a V8?
________
Kitchen Measures

speedo is cable all gauges used for 5.0 ford

ford150 wrote:speedo is cable all gauges used for 5.0 ford

still want rad and fan too?

Depends on $. Got enough for guages. PM a phone # and best time to call.

Jim
________
Glass weed pipe

tool box is ~70 long-20 wide- 61 between rails- 15 deep measurements not exact but close