Page 1 of 1
jeep junk question
Posted: Sun Sep 21, 2008 10:45 pm
by csult
is a 258 and 4.0 the same block? reason im im sakin is the 304 and 258 have the same bell houseing right? im kinda thanking aboult putting a 304/306/ or a 401 in my tj
Posted: Sun Sep 21, 2008 10:51 pm
by TerryD
I wouldn't waste my time with it. Stick with the 4.0L and maybe build a 4.5/4.6 stroker out of it. The AMC motors are the finest made, but they are hard (probably impossibe) to get to work in a computer controlled vehicle. If you want a v8 in something, buy a CJ and go that route, faster, easier, and in the long run cheaper. But you'll miss fuel injection...
Posted: Mon Sep 22, 2008 9:29 am
by hklvette
Unless you use TBI on a SBC...
Posted: Mon Sep 22, 2008 11:48 am
by TerryD
Still a waste of time in a TJ. EVERYTHING in the TJ is controlled by the ECM. You take that out and you have to replace the tach, tem, charge, oilpressure gauges, speedometer, transmission (if its an automatic), and you'd be a lot better off buying a CJ, putting in a EFI V-8 of your choice, buying axles that will take it and four linking it yourself....
Posted: Mon Sep 22, 2008 12:11 pm
by hklvette
TerryD wrote:Still a waste of time in a TJ. EVERYTHING in the TJ is controlled by the ECM. You take that out and you have to replace the tach, tem, charge, oilpressure gauges, speedometer, transmission (if its an automatic), and you'd be a lot better off buying a CJ, putting in a EFI V-8 of your choice, buying axles that will take it and four linking it yourself....
Oh...I wasthinking about SBC in a CJ. Agreed on the TJ being a b!tch to swap.