Sinking Creek 4WD Association

i am looking for a set of hubs and rotors for 76-94 ford f150 for my dana 44 axle swap if any one has or knows where to find set id apriciate it

i have a small bearing 44 hub ... 8 lug ... or are you looking for a 5 lug??

F150 would be 5-lug.

Honestly, I'd just buy them new. If you shop around you can find the hubs and rotors pre-assembled with studs and bearing races, and oddly the assembled set is sometimes cheaper than a hub alone. If you snag some old hubs from a junkyard or donor truck, you run the risk of the sealing surface for the lockout being jacked up and water gets in there.

I got mine from NAPA. I did once see a new hub explode around the lockout once... I think it was an Autozone or Advance store brand. Terry or Grubb might remember exactly which it was.

r u the guy with the blue rangere?

yes

Those were Autozone hub/rotor combos, but Matt is running them on his F-150 w/o incident.

yeah ive called around and a new set is kinda pricey i jus got the gears and the bearing kit and trying to find someone to install the gears so trying to keep it low budget as possible til i get it to were its under the jeep jeffs bronco grave yard has the combo new for 89 bucks a side

ive seen the ranger b4 i live 2 blocks down from were its parked that thing looks well built ive stoped and checkd it out walking up to my buddys house on clay st

I think that ranger must have gotten towed cause I have not scene it there for a while.

i usually see it in that apt parking lot