Page 1 of 1
D-ring Shackle Mounts
Posted: Tue May 16, 2006 10:15 am
by Ctrow
Does anyone know where I can get some weld-on cleivs D-ring mounts? Tryig to add some to my front bumper.
Posted: Tue May 16, 2006 10:39 am
by yotacowboy
call up BTF, i'm pretty sure they've got some.
Posted: Tue May 16, 2006 11:53 am
by Username
BTFs are nice. 1" thick and contoured to fit tubes. I have an extra set of thier 1/2" thick mounts they install on their bumpers. They sent me them by mistake and I have no use for them. PM or email me if you want them.
Posted: Wed May 24, 2006 10:39 am
by Ctrow
found a site
www.rokmen.com they're $10 each and free shipping if you buy 6
Posted: Fri Aug 25, 2006 11:49 am
by Trailduster79
I know it has been a while since this post was posted, but hit up Tractor Supply in C'burg. That's where I got mine from.
Posted: Fri Aug 25, 2006 1:14 pm
by CRAWL3R TJ
Trailduster79 wrote:I know it has been a while since this post was posted, but hit up Tractor Supply in C'burg. That's where I got mine from.
I don't believe they sell the mounts that you weld to the bumper, unless I haven't seen them yet.
Tractor Supply does carry the D-ring shackle. You can get either the Warn for about $22 and about a 3 ton rating or go with the generic brand for $13 with about a 6.5 ton rating. Northern also carries the 6.5 ton shackle for $10. Those are the ones I bought for my recovery needs.
Posted: Fri Aug 25, 2006 1:21 pm
by currupt4130
I've got a buddy that makes them. He's fairly cheap. If you want his info pm me. They're 3/4" thick, and about 4 inches long. Good for putting all the way through a bumper.
Posted: Fri Aug 25, 2006 2:19 pm
by Trailduster79
I know mine came from there cause that is where I got them from.
I will see if I can dig some pictures of them up.
BRB
Posted: Fri Aug 25, 2006 2:24 pm
by Trailduster79
here is a pic of my bumper with the D-ring mounts I got from tractor Supply. Granted it was about 2-3 years ago, but non the less, I got them from TC[/img]