Page 1 of 1
Need help with header
Posted: Tue Apr 14, 2009 12:00 pm
by dgerm
Doers anyone have some spare time this week to lend a hand. I need access to some basic tools and some floor jacks. I am new here and don't know how compensation goes but with rugby it usually consists of your choice of beverages. Here is the list of tools and I have the entire install guide as well. Let me know if you can't see the image
Posted: Tue Apr 14, 2009 12:27 pm
by TerryD
Wish I could help, but it looks like I may be working a long week. Anyways, here's some "compensation free" advice. Start spraying EVERYTHING you think you might need to take off or loosen with PB Blaster. Spray it 2-3 times daily, and with the zeal of someone about to loose their virginity. To improve the function, take a small (ultra small) hammer or a wrench and tap on the bolt and surrounding area lightly for a few moments to break the surface tension and allow it to soak in good. Best of luck!
Posted: Tue Apr 14, 2009 12:48 pm
by dgerm
TerryD wrote:Wish I could help, but it looks like I may be working a long week. Anyways, here's some "compensation free" advice. Start spraying EVERYTHING you think you might need to take off or loosen with PB Blaster. Spray it 2-3 times daily, and with the zeal of someone about to loose their virginity. To improve the function, take a small (ultra small) hammer or a wrench and tap on the bolt and surrounding area lightly for a few moments to break the surface tension and allow it to soak in good. Best of luck!
Thanks for the reply! i was also advised to run the truck for a few minutes to heat everything up a tad. I am mostly worried about the torquing part and my lack of tools living on campus
Posted: Tue Apr 14, 2009 3:06 pm
by MtnToys
I have all the tools you need. If you don't mind working in a gravel drive way, give me a call 717-514-2992.
Posted: Tue Apr 14, 2009 4:43 pm
by BadnewsCJ
good choice in headers
Posted: Tue Apr 14, 2009 6:23 pm
by dgerm
MtnToys wrote:I have all the tools you need. If you don't mind working in a gravel drive way, give me a call 717-514-2992.
That sounds awesome! I will give you a call when everything arrives!
Posted: Wed Apr 15, 2009 12:16 pm
by MtnToys
If you got all your parts in, I'll be around my place all afternoon.
Posted: Wed Apr 15, 2009 4:26 pm
by dgerm
No headers or hardware yet. I will keep you posted
Posted: Sun May 24, 2009 6:51 pm
by dgerm
dgerm wrote:No headers or hardware yet. I will keep you posted
Ok I am ready to give this a try, if anyone knows what they are doing and are willing to help, give me a call at (703) 674-6315