Page 1 of 1
Anybody got some D60 setup bearings?
Posted: Mon Aug 17, 2009 5:54 pm
by Andrew
Need to borrow a set to do some gears. I am in Blacksburg.
Thanks,
Andrew
Nevermind
Posted: Sat Aug 22, 2009 8:44 am
by Andrew
Spun carrier bearing. :(
Need a new housing.
Posted: Sat Aug 22, 2009 8:54 am
by TerryD
Is it spun so bad the new bearing slides on easily? I've setup pinions where the bearings could be pushed on and off by hand without any issues. Is it a front or rear axle? If it's a front, they see very little high speed use where this would pose a problem. If it's not super loose, use some green loc-tite, it's for securing sleeves and bushings.
Bearings
Posted: Sat Aug 22, 2009 4:05 pm
by Andrew
It spun the carrier bearing cup in the housing.
Picked up a junkyard axle
Posted: Sat Aug 22, 2009 10:06 pm
by TerryD
AH, spun the race... that sux...