Sinking Creek 4WD Association

a couple pics showing where i'm at on my build:

Rough idea of what were shooting for:

Looking good Peter, keep it up

so when does the back half come in the mail?

but serious question: does the tubework in the rear tie into some kind of interior roll cage?

Big Blue Bus? I thought this thing was coined the "Bluedonka Dodge" a few years ago Great progress man

Steinberg wrote:
but serious question: does the tubework in the rear tie into some kind of interior roll cage?

it will be tied in to the front of the truck w/ an exo, or at least some tube across the roof and windshield area just to get me on the trail. The reason I say "some tube" is because once I finish the rear half, i still have to do the front end(probably 3-link w/ panhard) and move the front axle forward ~5-6". Rear axle will stay in roughly the same location, maybe 5" forward.

Havent decided if I want to do an interior cage or not. I kind of like the idea of having an exo to act as a rock slider if I can get it close enough to the body to not cause a spot to get hung up on. Maybe Ill do a combination of both.

shmoken875 wrote:Big Blue Bus? I thought this thing was coined the "Bluedonka Dodge" a few years ago Great progress man

lol, i dont care what its called as long as I get on the trail within the year

Did Leach draw that? I've got several similar looking drawings by him.

tsmall07 wrote:Did Leach draw that? I've got several similar looking drawings by him.

you mean the shocker on the window? yeah, I bet that was leach...

Yes, Leach did in fact draw the shocker as well as the drawing on the dry erase board lol

Looking good Peter. You're going to have a lot going on cantilevered off that rear frame connection. I would very seriously consider taking some tubes from your rear hoop into the cab under the rear window and down to the frame near the a-pillars. These will also create nice door bars for you. You can also run a harness bar across them if you so choose.

This is how I did it on the yota and I think it's the easiest/strongest way of tying everything together without a full interior cage.

Let me know if my explanation wasn't very good and you'd like to see some pics.

Ary

Thats a good idea arya. Could also mount seats off that as well and still be able to keep my doors on for the cold times of the year. Ill check out your build thread on PBB

Hey Peter, I don't know what you guys have down there for heat, but I have a small propane infrared heater that you can use. Makes a big difference in my shop especially if you are in front of it. You are welcome to use it until I need it (which isn't likely lol).

Nice job so far. Glad to see you back at it.

James, its definitely been freezing cold in the shop. Was thinkin bout getting the big heater in the ceiling turned on, but that turned out to be more expensive than I wanted to pay. I might have to take you up on that offer. Ill call ya in the next few days, I'm workin repos this weekend so I won't be over there till probably Monday

James, its definitely been freezing cold in the shop. Was thinkin bout getting the big heater in the ceiling turned on, but that turned out to be more expensive than I wanted to pay. I might have to take you up on that offer. Ill call ya in the next few days, I'm workin repos this weekend so I won't be over there till probably Monday