Page 1 of 1
Steering Knuckle Machining
Posted: Tue May 11, 2010 2:41 pm
by zach119
Anyone ever use a service like this to get a steering knuckle tapped. For the price it doesn't look like a bad deal to include the keyed steering arm.
http://cgi.ebay.com/ebaymotors/DANA-44- ... 5fServices
Does anyone else have any other company they'd reccomend instead of this one?
Posted: Tue May 11, 2010 2:59 pm
by willhf1011
I haven't seen any other companies selling keyed 44 arms. I had AOI drill and tap mine, cost about 50 but I already had my steering arms and all. That doesn't seem like a terrible deal considering you get the arm. If you're not set on keyed arms I imagine theres someone local to you that could tap the knuckle and then you could run normal arms, otherwise off the top of my head I know ballistic can do mail in orders.
Posted: Wed May 12, 2010 1:00 pm
by Fonger
WWW.SHAKERBUILT.COM
He's over in Tidewater and does great work. Support the local guy.
Posted: Mon Jun 07, 2010 10:53 pm
by archebald23
how much should one of these cost? im rooting for an oem part but im afraid id have to touch my savings on it.
_________________________________
did my turn signal assembly.. it rocks!
Posted: Tue Jun 08, 2010 12:21 am
by zach119
archebald23 wrote:how much should one of these cost? im rooting for an oem part but im afraid id have to touch my savings on it.
_________________________________
did my
turn signal assembly.. it rocks!
I'm guessing you have an OBS chevy going by your signature, you should definitely POR 15 your frame and get some sweet bosch wiper blades.
Posted: Tue Jun 08, 2010 10:04 am
by BadAssEddie
dodgeguy119 wrote:I'm guessing you have an OBS chevy going by your signature, you should definitely POR 15 your frame and get some sweet bosch wiper blades.
