Page 1 of 1
Dana 44 Gear Install ?
Posted: Thu Dec 01, 2011 10:39 pm
by jstables
Does this kit have everything I need for? Im also gonna get axle seals to install while the carrier is out.
http://broncograveyard.com/bronco/i-121 ... ings-.html
Will...
Posted: Fri Dec 02, 2011 12:52 am
by TerryD
For the front? It doesn't have the spindle seals or bearing. No big deal, auto parts stores carry them. Looks like everything else is there!
Posted: Fri Dec 02, 2011 6:38 am
by jstables
TerryD wrote:For the front? It doesn't have the spindle seals or bearing. No big deal, auto parts stores carry them. Looks like everything else is there!
Already have those. As well as hub seals and I cleaned out and repacked the bearings so they should be good to go.
Posted: Fri Dec 02, 2011 10:51 am
by willhf1011
Yeap that's everything. I pulled your old carrier bearings off, You're welcome to use my die grinder sometime to make them into setup bearings if you want.
Posted: Fri Dec 02, 2011 11:38 am
by jstables
willhf1011 wrote:Yeap that's everything. I pulled your old carrier bearings off, You're welcome to use my die grinder sometime to make them into setup bearings if you want.
Awesome thanks man. I'm gonna order the kit today so hopefully everything comes in time to get those gears installed before break. I'm excited to get home and put the front end back together. I'm gonna be ready to build driveshafts over break if all goes well and I get the rear swapped in.