Sinking Creek 4WD Association

So I'm in P4 right now trying to replace my pinion seal. Problem is I don't have an impact gun and can't get the stupid thing off. With a 2ft breaker bar the pinion just rotates a little. Anyone have any tips or tricks on how to get this thing off?

Large pipe wrench to hold the yoke, wedged against the frame, floor, anything solid. Use as long a cheater bar as necessary, I'd start with a 4-5 footer.

Wes, Ive had luck doing my front and rear pinion seals loosening the nut with a wrench and hi-lift handle as a breaker bar. Alternatively, you could use a Pipe wrench on the yoke so that it hits the ground as you try to turn the nut off.

Ive got an impact and the driver you need to do this. Can swing by my place(christiansburg) tomorrow if you want. We can get it done pretty quick. Pm me.

Collison wrote:Ive got an impact and the driver you need to do this. Can swing by my place(christiansburg) tomorrow if you want. We can get it done pretty quick. Pm me.

I really appreciate it.

Pinion seal is on hold for now. Got in an accident on my way home last night. Some.idiot pulled out in front of me.

Damn. Just a scratch on the Jeep though? Hope you are ok!

Might get the jeep back today!! Probably tomorrow though