Page 1 of 1
D44 axleshafts
Posted: Wed Dec 27, 2006 12:45 am
by BlueDodgeRam
if anybody has any D44 axleshafts(30 spline) with CAD, let me know. im tryin to get spare parts together. also lookin for Chrysler 9.25 shafts, but i doubt anybodys got those.
hope everybody is havin' a good holiday season
Posted: Fri Dec 29, 2006 1:34 am
by Steinberg
CAD front axle? do you know the shaft lengths?
Posted: Fri Dec 29, 2006 1:36 am
by BlueDodgeRam
yes, CAD sorry didnt post that. drivers side drop as well
Posted: Fri Dec 29, 2006 1:38 am
by Steinberg
added above- what are the shaft lengths?
Posted: Fri Dec 29, 2006 1:41 am
by BlueDodgeRam
not sure, never pulled em out.
Posted: Fri Dec 29, 2006 1:43 am
by Steinberg
i have a short (~16") shaft sitting here. i believe it came out of some dodge w/ unit bearings, but that's all I can tell ya.
Posted: Fri Dec 29, 2006 1:47 am
by BlueDodgeRam
cool, ill check it out when i get back to school if i havent found any by then. ill probably get a full set f&r from somebody on pirate or PS.com. just posted up here to see if anybody had any. thanks though man
Posted: Wed Jan 03, 2007 3:16 pm
by Trailduster79
What year 9.25?
I have some shafts laying around for the 79 and older 9.25's with the 5x4.5 bolt pattern, and I have a complete 87 9.25 as well.
Let me know.
Michael
Posted: Wed Jan 03, 2007 3:18 pm
by BlueDodgeRam
its for my '01 Ram, so i dunno if itll work or not
Posted: Thu Jan 04, 2007 8:52 pm
by Dieselram
I have a spare hub bearing from my old 98 i dunno if it will work on your truck or not