Page 1 of 2
Ford 9 inch
Posted: Wed Feb 07, 2007 3:29 pm
by Jwlman
I have a ford 9" out of a 1978 f-150. $250
I believe it is a big bearing 31 spline
You know you want it cody. Replace that dana 35
Posted: Wed Feb 07, 2007 3:51 pm
by tsmall07
why don't you replace your dana 35 with it?
Posted: Wed Feb 07, 2007 4:04 pm
by Jwlman
tsmall07 wrote:why don't you replace your dana 35 with it?
Cause my dana 35 is sitting on the floor of my garage and it wouldn't do much good there
Posted: Thu Feb 15, 2007 8:44 pm
by jonesy
you selling that D44 too?
Posted: Thu Feb 15, 2007 9:28 pm
by Jwlman
affende wrote:you selling that D44 too?
Yes for $300
Posted: Thu Feb 15, 2007 9:31 pm
by Arya Ebrahimi
Do you know what gears it has?
Posted: Thu Feb 15, 2007 9:32 pm
by Jwlman
Buy them both and I will even help you install them
Posted: Thu Feb 15, 2007 9:32 pm
by Jwlman
Never had a chance to check but most likely 3.55s and possibly 4.10s
Posted: Wed Feb 21, 2007 5:12 pm
by Jwlman
both axles for $400.
Someone buy these. I need the money
Posted: Fri Mar 02, 2007 9:04 pm
by JPN High
These still forsale? I might have someone interested.
Posted: Fri Mar 02, 2007 11:59 pm
by hssss
I would be interested in the radius rods. PM with a #.
________
Toyota Boshoku Specifications
Posted: Sun Mar 04, 2007 1:11 am
by Jwlman
hssss wrote:I would be interested in the radius rods. PM with a #.
Damn, wish I saw this earlier. I just finished cutting them off.
The axles are sold
Posted: Sun Mar 04, 2007 3:06 am
by hssss
I need the spring pockets, shock towers, frame mounts, etc. I'm putting a YJ on a 79 Bronco chassis and want to use the front suspension setup for the rear for articulation and to allow shortning the wb.
________
Hotbox Vaporizers
Posted: Sun Mar 04, 2007 12:05 pm
by Steinberg
you cut them off?!?!?
Posted: Sun Mar 04, 2007 12:39 pm
by Jwlman
Steinberg wrote:you cut them off?!?!?
Yea, turnes out that the dana 44 I got is an eariler one cause the radius arm mounts were weled on and not cast on so I can still use the axle