Sinking Creek 4WD Association

I was looking at Cody's TJ front shaft and it looks to have a very similar CV as my ranger shaft, and it is very nearly the right length that I'd need with the doubler in. Do you guys know what size u-joint and CV these shafts have? And Cody, I'm gonna want to get a length measurement off your's. I looked up the weld-to-weld length, but that's dependant on whether the slipyokes are the same or not.

Don't quote me here, but I'm pretty sure that they are 1310 series joints.

U-joints are 1310, if it is a three speed automatic it should be 38.5" yoke to yoke, manual should be 40", newer 4 speeds should be even longer, but I don't know what they are. These measurements should be mid range length while in use, I believe the slip is 3 or 4". I have one out of an auto I could have measured, but it's already packed up to ship out to someone on ebay. My stock one is in pieces right now, but a new one should be here soon if you still need measurements by then.

Just found this on the internet, can not guarantee reliability. I would suggest one from a manual, they are beefier and heavier, as shown below, the diameter is larger, not sure what the wall thickness is on either, but I can confirm that the diameters and lengths seem about right...

4.0L 5spd MT 231 Transfer Case. Ujoint CV/1310. Diameter 2.50". 40.0" Ctr-Ctr. 25 5/8" Weld to Weld

2.5L & 4.0L AT, 231 Transfer Case. Ujoint Cv/1310. Diameter 1.75". 38.25 Ctr-Ctr. 24.5" Weld to Weld.

good info. the W-W lengths there correspond to what I found on car-part.com. I will have to measure tomorrow and compare the overall length. another lead I have is a fullsize ford truck front shaft, but need to confirm if they have the same joints or not. of course, this will all be moot if I cannot find a deal in the club or at a yard around here. if I was back in jersey at the u-pull I could have the fullsize ford shafts all day long for pennies on the dollar to what these "salvage yards" want.

I got a spare sittin around the apartment you can use to mock shit up whenever you want, just let me know.

well mine will be easy to measure as its sitting on my back porch lol