Collecting ARB's... Help me...

Post by **Arya Ebrahimi** » Tue Mar 04, 2008 9:13 pm

Benny, mrblaine on PBB is one of currie's lapdogs. He seems to be the engineering type and might take some interest in your project and be able to help you out with the info you're looking for.

Post by **Billet Benny** » Tue Mar 04, 2008 9:54 pm

I sent my email for a third time but this time to each individual email address from Currie's site and then I pm'ed mrblaine..
Thanks!

Post by **Billet Benny** » Wed Mar 05, 2008 3:21 pm

Well, I got somewhere. Kinda. I got an email back from Travis at Currie and he gave me info that conflicts with the website. He says the engineer said all the bars except the JK bars are .750". This is in direct contrast to what the website says and that is that all the different length bars available in universal kits are different diameters, as my chart shows. I also got some other info from him that showed me he got yet more confused with my second question. He also mentioned some diameters for the JK bars, but I'm not willing to trust that yet.

The good news is that I got the email address to the Currie "engineer" so I've sent him an email. We'll see what kind of an "engineer" he is and if he can give me trustworthy information. Hopefully someone can at least understand my question and be consistent with the information that is on the website.

Post by **Billet Benny** » Wed Mar 05, 2008 7:14 pm

David, the engineer, got back to me and hooked me up with the dimensions. I have now updated the 'bar chart'. <----that is an intended pun

The only question I left them with is if they have ever machine tested their bars to determine their real world rates.

I will model their rates and probably post that info in the Tech forum.