nearby junkyard v jeep stuff

Post by **jonesy** » Wed Aug 30, 2006 8:39 pm

i need directions and contact info to a nearby junkyard that mgiht have some jeep stuff...specifically V8 ZJ front springs.....

any help is appreciated

Cody

CRAWL3R TJ · Post by **CRAWL3R TJ** » Thu Aug 31, 2006 7:14 am

The only places I can think of is Bill's Used Parts and Agee's Used Parts. Both are located across from each other in Christiansburg on Radford Road.

From B-burg: Take 460 into C-burg towards downtown C-burg. After you pass Sheetz you will go another 4 or 5 lights(not sure since it has been a while since I went this route). You will pass a Kroger on your left and start down a hill. At the bottom of the hill is a stop light. Take a right. I think you go to the 2nd light and make a right onto Radford Rd (US 11). Travel about 4-5 miles and Bills will be on the left and another 1/8 mile Agees will be on the right.

Not sure if they will have any ZJ's so I would call first.

The other junkyard I use to frequent was D&M on Ellet Road, but they mostly deal in older vehicles.

concreteSwell · Post by **concreteSwell** » Thu Aug 31, 2006 9:37 am

Don't know how far you're willing to drive, but there are two here in Roanoke that have quite a many ZJs, 4.0L, 4.7L, 5.2L, 5.9L, etc. If you're willing to drive, I can look into it for you.

Post by **yotacowboy** » Thu Aug 31, 2006 10:05 am

There's also D&M here in B'burg.

They're down on Jennelle road.

Post by **jonesy** » Thu Aug 31, 2006 12:19 pm

thanks for the replies, gang....ill try the local ones and if nothing pops up i might be making a trip to your neck of the woods, concreteswell.

thanks again.

Post by **Leach** » Thu Aug 31, 2006 5:01 pm

There is also J and J's junkyard down in Radford. I dont know directions to it but I can get em/take ya there and we could find it if ya cant find parts anywhere else.

Leach

Flava-Puff Crawler · Post by **Flava-Puff Crawler** » Thu Aug 31, 2006 7:39 pm

Estes is also pretty close. They are in Pilot which is right outside of Christiansburg. Its a nice drive through the mountain.

Post by **shmoken875** » Thu Sep 14, 2006 4:01 pm

I just found this website: http://www.nrvbusiness.com/index.php?op ... &Itemid=26 it has pretty much everything auto around here, even the #'s and addresses for Bills, A.Agees, and D&M, unfortunately nobody has a pick n' pull lot (thats all I do back home). If anyone knows of a pick n' pull lot could you post up, I'm looking for an xj front driveshaft, some tj flares and possibly a np231 or 242 t-case to pull.

CRAWL3R TJ · Post by **CRAWL3R TJ** » Fri Sep 15, 2006 9:57 am

Depending on what you are looking for you can be accompanied out into the lot at Bill's. At least everytime I have been there they drove me out to the Wrangler section and let me pull my parts, then drove me back to the office. D&M will let you walk around their yard usually, then you come back to the office and tell the guy where the vehicle is and they go get it. I have also been allowed to walk out in the yard at Agees a couple times when I was looking for things. I would be leary pulling anything out of a vehicle at D&M since they tend to stack their vehicles.

I haven't been able to find a pick'n'pull yard around here. I usually have to go back to Richmond if I want to pull my own parts as well as pay about half what they want for used parts out here. For example, I went to the one junkyard in Richmond and pulled two rear axle shafts and paid less for both of them than any of the junkyards around here would have charged for one.

Post by **shmoken875** » Fri Sep 15, 2006 2:34 pm

god damnit, I hate paying somebody to pull my parts, we only have one of those back home. Bills wants between $45 and $65 for a shft that I can get for $10 at home.