Anybody got some D60 setup bearings?

Wrenching and Technical Information

Moderator: Club Officers

Post Reply
Andrew
Posts: 131
Joined: Thu Jan 10, 2008 2:14 pm

Anybody got some D60 setup bearings?

Post by Andrew »

Need to borrow a set to do some gears. I am in Blacksburg.

Thanks,
Andrew
Top
Andrew
Posts: 131
Joined: Thu Jan 10, 2008 2:14 pm

Nevermind

Post by Andrew »

Spun carrier bearing. :(
Need a new housing.
Top
User avatar
TerryD
Posts: 1905
Joined: Mon Sep 04, 2006 7:57 pm
Location: Covington, Va
Contact:
Contact TerryD

Post by TerryD »

Is it spun so bad the new bearing slides on easily? I've setup pinions where the bearings could be pushed on and off by hand without any issues. Is it a front or rear axle? If it's a front, they see very little high speed use where this would pose a problem. If it's not super loose, use some green loc-tite, it's for securing sleeves and bushings.
Terry
Offroading: The hobby of turning perfectly good vehicles into scrap metal. :cool:
Top
Andrew
Posts: 131
Joined: Thu Jan 10, 2008 2:14 pm

Bearings

Post by Andrew »

It spun the carrier bearing cup in the housing.

Picked up a junkyard axle
Top
User avatar
TerryD
Posts: 1905
Joined: Mon Sep 04, 2006 7:57 pm
Location: Covington, Va
Contact:
Contact TerryD

Post by TerryD »

AH, spun the race... that sux...
Terry
Offroading: The hobby of turning perfectly good vehicles into scrap metal. :cool:
Top
Post Reply

Return to “Technical”