So uh, despite holdin on for a fair bit and up to 70 mph, good ole JB-Weld finally let me down Although, I think it's leakin due more to a poor seal because of the thickness of the weld rather than the JB breakin down/crackin...
Either way, guess I need a new case half. I think the 231 parts out of a Durango would swap, but that still doesn't really help me out on findin the part for as cheap as possible... Ideas? Funds are low and it's my DD
Attachments
Before
Before.jpg (119.89 KiB) Viewed 4618 times
After.jpg (104.48 KiB) Viewed 4618 times
'03 TJ on Bronco Axles and 37s
'96 XJ Country DD on 32s
'96 KLX650c on my driveway
Haha you have had some bad luck lately sir. I have a stock complete np231 at home I just took it out of the white jeep when I put the 4:1 in it. Its on Craigslist for $75 bucks. Let me know if you have any interest in it and I will try to get it up here to school (for all the VA haters yeah thats right I said UP here )
Matt612 wrote: Let me know if you have any interest in it and I will try to get it up here to school (for all the VA haters yeah thats right I said UP here )
Hmmm... There any way you could ship it? I'd guess it would pretty expensive... But you got any idea how much we'd be talkin? I'm kina tryin to get my Jeep back up here ASAP cause I'm havin to drive the truck right now...
By the way, don't I still owe you for that axle shaft?
'03 TJ on Bronco Axles and 37s
'96 XJ Country DD on 32s
'96 KLX650c on my driveway
I could see if someone back home will box it up and ship it but it would be expensive, most likely somewhere from $50-75 bucks just to ship it. Haha and yes you still owe me for that shaft
Alright Matt, if ya still got the NP231, I'll take it But I guess hold off on the shippin though. I'll have to do some figurin on whether it's worth it to get it here sooner...
And I should be at the next meeting hopefully, so I'll pay ya for the shaft then
'03 TJ on Bronco Axles and 37s
'96 XJ Country DD on 32s
'96 KLX650c on my driveway
MtnManMatt wrote:Alright Matt, if ya still got the NP231, I'll take it But I guess hold off on the shippin though. I'll have to do some figurin on whether it's worth it to get it here sooner...
And I should be at the next meeting hopefully, so I'll pay ya for the shaft then
Haha sounds good bud. Next time I go home I will bring it back up here.
Matt612 wrote:Sorry man I didnt see this until now. It would cost at least $50 to ship it man if you can wait another week I will have it up here for you.
Alright man. I guess I'll just wait. Thanks though.
'03 TJ on Bronco Axles and 37s
'96 XJ Country DD on 32s
'96 KLX650c on my driveway
Although, I think it's leakin due more to a poor seal because of the thickness of the weld rather than the JB breakin down/crackin...
)
How long before ya could get it up here though?
