Pattern check please.

Wrenching and Technical Information

Moderator: Club Officers

Post Reply
User avatar
Steinberg
Posts: 2182
Joined: Tue Dec 14, 2004 9:52 pm

Pattern check please.

Post by Steinberg »

Specs: HP44, Genuine Gear 4.56, Detroit
Backlash is at 0.009"

Drive:
Image
Two shitty pics makes one good pic, right?
Image

Coast:
Image
The Rescue Ranger: in pieces and scattered about the yard.
User avatar
Fonger
Posts: 417
Joined: Wed Dec 15, 2004 2:48 am
Location: Out the ridge
Contact:

Post by Fonger »

I'd run it! If anything it's a little deep, but it's too close to try and find the "perfect pattern". So keep it and run that puppy. Just be sure you follow the directions for breaking in your gears. Lookin' good Steinberg :thumby:
I feel like a hundred bucks...
User avatar
Steinberg
Posts: 2182
Joined: Tue Dec 14, 2004 9:52 pm

Post by Steinberg »

cool. if anything I thought it was a bit too shallow. I think the pics are a bit decieving in that sense. i just hope it doesn't change too much when i press on the final bearings.
The Rescue Ranger: in pieces and scattered about the yard.
Post Reply