Sinking Creek 4WD Association

Rockstomper and KOZ used to both make a set that clears, I imagine they still do.

Anybody have a tubing flaring tool for brake line and a cutter ? I wanna try to get brakes working on my rig.

jstables wrote:Anybody have a tubing flaring tool for brake line and a cutter ? I wanna try to get brakes working on my rig.

Advance rents them fo free.

I do, I will have to see if its here or in my box at home though.

Thanks to alec I got my rear perches rewelded and made another driveshaft. Next on the list is to redo my transmission crossmember because it has started to bow a little and Im gonna send my knuckle out to be machined for high steer arms.

on a side note can someone tell me which one of these is bad...

The one on the left looks like shit but the one on the right looks minty clean...I would run the right one.. much better flow

Three Fiddy

helll yeahhhh

You gonna run the sm465?

^^ probably not I'm just gonna stick with an auto to get things going faster

hell yeah very nice

Quick update. I got the engine and trans split today and borrowed a stand for it. Also I have pulled off the manifolds and so far so good its a 30+ year old motor and every single bolt has come loose with ease so far.

When you putting this sucker in?

Things are finally happening.

Matt612 wrote:When you putting this sucker in?

This week if all goes well.

Dont forget the weld on your motor mounts