WWJD (currie 9")?

[shmoken875]

Here are the prices I just sold all my 9" stuff for.

Full detroit run briefly: $350
nodular third with new pinion bearing: $300
Complete housing freshly cut from under the truck axle: $150

I can't remember what I sold the 5.13s for

You won't need to pay more than that (or even that much) to have a setup that is more than strong enough for you.

just the numbers I was looking for. I had my eyes on a 9 in the rear of an old F100 but I think its gone now. I've been combing craigslist and forums for a while now, just need to get my lazy ass back in the junkyard. been too long

[Jwlman]

Here are the prices I just sold all my 9" stuff for.

Full detroit run briefly: $350
nodular third with new pinion bearing: $300
Complete housing freshly cut from under the truck axle: $150

I can't remember what I sold the 5.13s for

You won't need to pay more than that (or even that much) to have a setup that is more than strong enough for you.

just the numbers I was looking for. I had my eyes on a 9 in the rear of an old F100 but I think its gone now. I've been combing craigslist and forums for a while now, just need to get my lazy ass back in the junkyard. been too long

http://marylandcreepers.com/MCForums/vi ... =4&t=42669

[tsmall07]

http://marylandcreepers.com/MCForums/vi ... =4&t=42669

Just wanted to make sure you see thats from an Early Bronco. Won't be full width, which may or may not fit your purpose better.

[hssss]

Ask
Ary about Mazdas Versailles 9" which should be the right width but is 5 on 4.5.
________
Ford thunderbird

[shmoken875]

Ask
Ary about Mazdas Versailles 9" which should be the right width but is 5 on 4.5.

actually I already snagged 9" for dirt cheap, but thanks for the heads up man