Sinking Creek 4WD Association

been doin a little work. no front axle yet so i'm just working what i can since i have a lot of free time jobless and all.



thinking about tying them together and i need some longer bolts but they are 6 in eye to eye

got a free tool box and made a little box where the rear seat was so i can store stuff under there.




sliders and some fresh paint.

nice work john

thanks rant. and i did burn two more lbs of rods into the 60 from will. and the tranny cooler the PO had put on i found to be clogged so i blew that out and it has a lot better response from the trans now.

bought a set of wagon wheels...




they are 16.5 x 9.75 and later on i plan on getting some weld on beadlocks for them.

So what are the ultimate plans? build the 84?

yeh. for now though i'm probably just gonna put some 32's on it and wheel it till i find/buy the front axle i'm looking for.

jstables wrote:yeh. for now though i'm probably just gonna put some 32's on it and wheel it till i find/buy the front axle i'm looking for.

32s on a dana 60? wont ever break anything

32's on stock shit.

forget the stock lifted wheeling idea. bought this today

details on the axle?

It's a dana 44 out of a late seventies f250. I bought it for a $100 bucks but it has 3.54 gears so i'm gonna need to regear. Otherwise the brakes were fully intact and the pads look good so i'm gonna keep them. The hubs just look old but i'm gonna tear them down and get a better look as soon as i borrow the socket for it. And the shafts look rough defiantly need some new u-joints but more likely new shafts.

picked these up to day.

52" chevys - $25

Ready to start tearing things apart.

new cb mount



front end cut off



front end under and tacked just need to get rear hangers on and pull everything apart to finish weld.

God would not approve of the above profane hand gesture.