For Sale:
78 CJ-7
Bought off a guy three years ago who started a frame up restoration then decided to sell. Then it was rebuilt by myself and put on the road about a year ago. Since then it has less then 175 miles on it.
Rebuilt 304 V8
bored 0.030" over
flat top pistons
204/214 dur @ 0.050" cam
polished rods
edelbrock intake
edelbrock 650 cfm carb
headman fenderwell headers & glasspacks
tfi ignition
rebuilt th400
rebuilt quadratrac with low range
dana 30/model 20 open 3.54
power steering
power brakes
tilt steering
front hoop added to the rear roll bar
front and rear fenders cut out
spray can paint job - navy blue
new starter
alternator
water pump
brake lines
front rotors
front calipers
gas tank
low back seats
fuel & temp gauge
B&M Shifter
PS pump & hoses
and many other new parts not on the list.
bikini top and soft doors only
The body on this Jeep needs some work. There is rust around the rear wheel wells and along the floor. The rear body mounts are rusted out and body mounts under the rear deck were cut out by the previous owner. The headlights cut out intermitently after ~10 minutes, the windshield wipers work sparatically, and the blower motor does not work).
The frame is completely rust free and the rear most 18" and rear crossmember have been made from box tubing.
This jeep is a solid platform for a build-up with a stout frame, engine, and transmission. I am asking $2500. No Trades. The jeep is located in Blacksburg, VA. Email me bmcninne@vt.edu
