Sinking Creek 4WD Association

Whats my options? The angle shouldn't be too bad.. i'm using trail gears 3" kit. Is there an easy solution to it or will I have to lengthen a sfa driveshaft or make a new one?

I dont know of any factory application that will work. You end up with too much travel in the springs for factory parts. My searching shows 4 options.
Call someone and have one made professionally around 300$
Order a long travel shaft kit from one of the yota vendors 200$
Use tractor pto shaft parts 50$-100$
Use square tube 30$
The square shaft is a very common solution and very strong and you can always make a better shaft later. My square shaft is good up to around 30-35 mph before the vibes start.

Thats kind of what I have been finding as well. It seems a lot of guys are using a hybrid of of the ifs ds and the sfa ds and just having it extended.

I guess the best thing for me to do is to wait on it and get the axle under it then start measuring.

What shops around make driveshafts?

Dont use the TSC pto parts. My spare shaft is made out of them. They twist very easy. I had the 12" extension given to me that was already twisted some, but could still be used as a spare if need be. Currently I have a Trail-Gear 12" drive shaft kit.