Sinking Creek 4WD Association

I have a welded carrier and 2 sets of 4:10 gears with bearings from SA front diffs (should be low miles) they were still tight when disassembled. If any of this is any interest to anyone just make an offer. Would consider trade for driveshaft parts.

Parts are from standard 8" diffs

trade ya two diffs with 4.10's with bad bearings for 1 of your diffs with good bearings?

i think the whole point was that he was trying to get rid of having 4.10s in the first place. can i "borrow" your carrier for big dogs Adam

Stinson wrote:trade ya two diffs with 4.10's with bad bearings for 1 of your diffs with good bearings?

The gears have been pulled from the diffs so thay would need to be setup in another 3rd

Yoda wrote:i think the whole point was that he was trying to get rid of having 4.10s in the first place. can i "borrow" your carrier for big dogs Adam

If you want to use it thats fine, I dont think it will fit a taco though?

you're probably right, its out of your 83 right? maybe if i had the 8.0 housing instead of the 8.4

Yoda wrote:you're probably right, its out of your 83 right? maybe if i had the 8.0 housing instead of the 8.4

It is a standard 8" carrier

I have an 8" third out of my 4runner that needs a 4.10 r&p... Still got one?

I still have 2 complete sets of 4:10s with all of the bearings if you need them.

how much?

will 20$ be alright?

Will 4cyl gears fit a V6 carrier? Not sure, so I thought I'd pose the question.

I am not sure, but as long as its the standard 8", it should swap out... I can take my broken one apart and we can compare them before i buy. Ill let you konw when its apart.

Arya Ebrahimi wrote:Will 4cyl gears fit a V6 carrier? Not sure, so I thought I'd pose the question.

i think you have to do some swapping between the pinion bearings ... one bearing will be 4cyl and the other bearing will be 6cyl .... not sure which is which...

krantz, you still have these? ive got a buddy up here that needs some 4.10s for an SFA
________
stock picks

Still got em.