Anyone have experience with a dana 20 xfer case?

Wrenching and Technical Information

Moderator: Club Officers

Post Reply
User avatar
BadnewsCJ
Posts: 1288
Joined: Wed Nov 15, 2006 1:47 pm

Anyone have experience with a dana 20 xfer case?

Post by BadnewsCJ »

The dana 20 in my cj wont turn the front yoke in 4L. I can drive it in rear wheel, but the front driveshaft does not spin. 4H works as it should, as does 2H. Just 4L only spins the rear yoke. I had the 20 out just to replace a few gaskets and change the oil when i did my tranny swap and it worked previous to pulling it out so i dunno what happened. Im assuming ill have to pull it to fix it cause the linkage seems to be engaging it fine. If anyone has any experience on where to look inside this thing or just has one for sale, your help would be greatly appreciated. Thanks guys.
Nick
Nick
'79 Jeep
'99 F350 tow rig
'13 TDI Wagen DD
User avatar
yotacowboy
Posts: 581
Joined: Thu Dec 16, 2004 6:28 am
Location: b'burg
Contact:

Post by yotacowboy »

Check out BillaVista's D20 builds and tech articles on Pirate4x4:

here's one of 'em:

http://www.pirate4x4.com/tech/billavist ... index.html
'91 Reg. Cab Yota DD: DOA 22re RV, .060 over,270 cam,ported,Thorley Tri-Y,2.25 cat,Flowey 40,SAS'd,Locked,Longed,Pig'd,Bumpered,Slidered,Sky wide axle,5.29's,Duals,Sky Tcase skid,37" Iroks,2.5" BS blk steelies,Allpro Hy-steer,HighAngle D-lines
User avatar
BadnewsCJ
Posts: 1288
Joined: Wed Nov 15, 2006 1:47 pm

Post by BadnewsCJ »

yea ive looked through those before. thanks for pointing them out i forgot about em. ill see what i can find.....
Nick
'79 Jeep
'99 F350 tow rig
'13 TDI Wagen DD
Post Reply