The dana 20 in my cj wont turn the front yoke in 4L. I can drive it in rear wheel, but the front driveshaft does not spin. 4H works as it should, as does 2H. Just 4L only spins the rear yoke. I had the 20 out just to replace a few gaskets and change the oil when i did my tranny swap and it worked previous to pulling it out so i dunno what happened. Im assuming ill have to pull it to fix it cause the linkage seems to be engaging it fine. If anyone has any experience on where to look inside this thing or just has one for sale, your help would be greatly appreciated. Thanks guys.
Nick
Anyone have experience with a dana 20 xfer case?
Moderator: Club Officers
Anyone have experience with a dana 20 xfer case?
Nick
'79 Jeep
'99 F350 tow rig
'13 TDI Wagen DD
'79 Jeep
'99 F350 tow rig
'13 TDI Wagen DD
- yotacowboy
- Posts: 581
- Joined: Thu Dec 16, 2004 6:28 am
- Location: b'burg
- Contact:
Check out BillaVista's D20 builds and tech articles on Pirate4x4:
here's one of 'em:
http://www.pirate4x4.com/tech/billavist ... index.html
here's one of 'em:
http://www.pirate4x4.com/tech/billavist ... index.html
'91 Reg. Cab Yota DD: DOA 22re RV, .060 over,270 cam,ported,Thorley Tri-Y,2.25 cat,Flowey 40,SAS'd,Locked,Longed,Pig'd,Bumpered,Slidered,Sky wide axle,5.29's,Duals,Sky Tcase skid,37" Iroks,2.5" BS blk steelies,Allpro Hy-steer,HighAngle D-lines