1984

Post by **jstables** » Thu Jun 17, 2010 10:48 pm

been doin a little work. no front axle yet so i'm just working what i can since i have a lot of free time jobless and all.

thinking about tying them together and i need some longer bolts but they are 6 in eye to eye

got a free tool box and made a little box where the rear seat was so i can store stuff under there.

sliders and some fresh paint.

Post by **shmoken875** » Sat Jun 19, 2010 5:01 pm

nice work john

Post by **jstables** » Mon Jun 21, 2010 11:03 am

thanks rant. and i did burn two more lbs of rods into the 60 from will. and the tranny cooler the PO had put on i found to be clogged so i blew that out and it has a lot better response from the trans now.

Post by **jstables** » Fri Jul 16, 2010 10:49 pm

bought a set of wagon wheels...

they are 16.5 x 9.75 and later on i plan on getting some weld on beadlocks for them.

97JEEPTJ · Post by **97JEEPTJ** » Fri Jul 16, 2010 11:11 pm

So what are the ultimate plans? build the 84?

Post by **jstables** » Sat Jul 17, 2010 12:01 am

yeh. for now though i'm probably just gonna put some 32's on it and wheel it till i find/buy the front axle i'm looking for.

Post by **BadAssEddie** » Sat Jul 17, 2010 5:36 pm

jstables wrote:yeh. for now though i'm probably just gonna put some 32's on it and wheel it till i find/buy the front axle i'm looking for.

32s on a dana 60? wont ever break anything :lol2:

Post by **jstables** » Sun Jul 18, 2010 8:09 pm

32's on stock shit.

Post by **jstables** » Mon Jul 26, 2010 10:22 pm

forget the stock lifted wheeling idea. bought this today

97JEEPTJ · Post by **97JEEPTJ** » Mon Jul 26, 2010 10:25 pm

details on the axle?

Post by **jstables** » Mon Jul 26, 2010 10:32 pm

It's a dana 44 out of a late seventies f250. I bought it for a $100 bucks but it has 3.54 gears so i'm gonna need to regear. Otherwise the brakes were fully intact and the pads look good so i'm gonna keep them. The hubs just look old but i'm gonna tear them down and get a better look as soon as i borrow the socket for it. And the shafts look rough defiantly need some new u-joints but more likely new shafts.

Post by **jstables** » Sat Oct 16, 2010 10:41 pm

picked these up to day.

52" chevys - $25

Post by **jstables** » Wed Dec 22, 2010 6:32 pm

Ready to start tearing things apart.

Post by **jstables** » Mon Jan 03, 2011 7:35 pm

new cb mount

front end cut off

front end under and tacked just need to get rear hangers on and pull everything apart to finish weld.

Post by **BadAssEddie** » Tue Jan 04, 2011 12:54 am

God would not approve of the above profane hand gesture.